TieLock™ Forming System Data Sheet

TieLock™ Forming System

A self-centering tie and locking bracket, with 3/4”

plywood and 2×4 lumber, for concrete forming

The TieLock self-centering tie and bracket, with 3/4”

plywood as 3/4” plywood as the form face and 2×4

lumber as the waler, creates an economical concrete

forming system.

The self-centering tie sets the wall dimension, fits

snugly against the plywood face, and breaks back

cleanly inside the plastic cone.

The typical tie spacing is 16”x24” for most concrete

walls. The TieLock Bracket hooks the tie loop, while

securely holding the 2×4 lumber walers.

A Strongback Bracket hooks onto the TieLock

Bracket when 2×4 lumber strongbacks are needed.

The safe working load of 2,250 lbs (2:1 safety factor)

is based on the tie capacity. It may be necessary to

adjust the tie pattern and/or concrete rate-of-pour to

stay within this limit.

The self-centering tie sets the wall thickness, fits

snugly to the form face, and breaks cleanly during

stripping. Optional water-resistant washer available at

an additional cost.

The TieLock Bracket, sometimes called a Camlock

bracket, has a pivoting handle that captures the tie

loop and 2×4 lumber waler at the same time.

A Strongback Bracket hooks onto the TieLock

Bracket when 2×4 lumber strongbacks are needed.

2525 Armitage Ave

Melrose Park, IL 60160

708-493-9569

www.surebuilt-usa.com

03/26