Construction Adhesive Data Sheet

Construction Adhesive
Position, bond, and remove materials in tilt-up casting beds
Construction Adhesive
A high-strength, fast-drying, low VOC, pressure- sensitive adhesive used for positioning chamfers, reveals and rustications in tilt-up casting beds.
The web spray adhesive is suitable for concrete, metal, plastic, wood, MDF, fiberglass, and other materials. Product offers heat and water resistance.
Construction Adhesive – inverted aerosol can
Construction Adhesive – canister
Canister Gun with Adjustable Flow Rate
Construction Adhesive Edge Form Bracket Installation
Constrution Adhesive & Accessories
Part No.
Description
Packaging
SBFCA14
Construction Adhesive – LVOC inverted aerosol spray – 14oz can
12/case, 108 cases/pallet
SBFCA28
Construction Adhesive – canister tank – 28 lbs
36/pallet
SBFAC5
Adhesive Cleaner – 5 gallon pail
36/pallet
SBFCGAF
Canister Gun w/Adjustable Flow
–
SBFCH12
Canister Hose – 12’ Length
–
840 South 25th Ave Bellwood, IL 60104 708-493-9569 www.surebuilt-usa.com
05/24

1. Allow sufficient concrete curing
Construction Adhesive Guidelines
Allow a minimum of three curing days (seven days preferred) after placing a concrete slab. Check for residual moisture before applying adhesive to a newly-placed concrete surface.
2. Carefully prepare the surface
Bonding surfaces (concrete, metals, plastics, wood) must be free of oil, dirt, dust and/or other particles. Use a hard bristle brush/broom to clean the surfaces. When necessary, use an angle grinder with a wire cup brush or Adhesive Cleaner.
3. Spray adhesive in a consistent pattern
Applicator tip should be approximately 10 inches from the surface. Constantly move the applicator to minimize overlap and/or over application. Several light spray applications typically provide more consistent and thorough coverage.
4. Provide adequate flash time
Adhesive should be applied to both surfaces, then allowed to “flash off” before matching and bonding those surfaces. Flash time is approximately 1-3 minutes depending on the ambient temperature and weather conditions.
5. Let adhesive dry
Adhesive should be dry to the touch on both surfaces before matching and bonding those surfaces. The adhesive can remain “tacky,” even when it is dry.
6. Apply even pressure to materials
Match treated surfaces and apply heavy, consistent pressure. When bonding longer lengths of materials, be sure they are positioned straight and flat. When bonding longer lengths of materials, be sure to allow approximately 1/16” space for expansion.
7. Check the base
Force from nail guns and/or other power tools can disrupt bonded materials. Allow bonded areas to fully cure before performing other forming operations. Use instant-bond Sticky Sheets to reattach dislodged materials.
8. Water resistance
For reveals and rustications, use impervious materials like plastics. Check adhesive and plastic compatibility before beginning any application. Do not attempt to match and bond wet materials. Incidental moisture after installation is acceptable.
Adhesive Cleaner
Adhesive Cleaner was designed to help clean up adhesive residue. The solvent system attacks residue and can be applied with a sponge and applicator. Adhesive Cleaner is great for removing common aerosol adhesives used in tilt-up construction.