Double Tee Anchor Data Sheet

Double Tee Anchor
Simple anchor design for lifting and handling precast concrete tees
The Double Tee Anchor is designed for lifting and placing precast concrete single and double tees. The anchor can be tied to the rebar or wet-set as needed.
The Double Tee Anchor can be used in a parallel (standard) or perpendicular (wide) direction, depending on the number and spacing of prestressed strands.
The “wavy” legs of the Double Tee Anchor integrate with the concrete for maximum load capacity and minimize inference with the prestressed stands.
The anchor is installed just below the concrete surface using a recess former. After removing the former, the top of the anchor is accessible for lifting.
The Double Tee Anchor remains in the concrete and the surface is easily patched, eliminating the removal costs associated with strand lifters.
A standard 10-ton Ring-Lift Lifter is needed for each anchor location during lifting and handling.
Double Tee Anchor Round Bar with Wavy Tail
Double Tee Anchor Square Bar with Wavy Tail
Double Tee Anchor* – Round Bar with Wavy Tail
Part No.
Description
Bar Size
Anchor Length
Anchor Width
Wave Width
Load Rating**
SBDTAS8T23RW
Double Tee Anch 8T Std Rnd
3/4”
23”
4”
1-1/4”
16,000 lbs
SBDTAW8T23RW
Double Tee Anch 8T Wide Rnd
3/4”
23”
5”
1-1/4”
16,000 lbs
* Minimum coverage of 3/4” from side of foot to edge of concrete. Minimum spacing 9” from end of double tee beam.
** Safe Working Load (SWL) based on 4:1 safety factor.
840 South 25th Ave Bellwood, IL 60104 708-493-9569 www.surebuilt-usa.com
01/24

Double Tee Anchor* – Square Bar with Wavy Tail
Part No.
Description
Bar Size
Anchor Length
Anchor Width
Wave Width
Load Rating**
SBDTAS8T23SQW
Double Tee Anch 8T Std Sq
5/8”
23”
4”
1-1/4”
16,000 lbs
SBDTAW8T23SQW
Double Tee Anch 8T Wide Sq
5/8”
23”
5”
1-1/4”
16,000 lbs
SBDTAS10T23SQW
Double Tee Anch 10T Std Sq
3/4”
23”
4”
1-1/2”
22,000 lbs
SBDTAW10T23SQW
Double Tee Anch 10T Wide Sq
3/4”
23”
5”
1-1/2”
22,000 lbs
* Minimum coverage of 3/4” from side of foot to edge of concrete. Minimum spacing 9” from end of double tee beam.
** Safe Working Load (SWL) based on 4:1 safety factor.
Anchor aligned to center of tee. Legs parallel to double rows of prestress strands.
Anchor aligned to center of tee. Legs perpendicular to single rows of strands.
Anchor aligned to center of tee. Legs perpendicular to double rows of strands.