Form Release 250

Technical Data Sheet
Form Release 250
Reactive form release agent
Description
Form Release 250 is a chemically reactive, mineral oil base, concrete release agent specially engineered to positively prevent bonding of the concrete to forms and form liners.
Form Release 250 contains no waxes or silicones.
• Improves release of formwork
• Reduces concrete buildup on formwork and liners • Reduces cleaning of formwork
• Protects formwork against rust
• Leaves no residue, stain or discoloration
• Helps reduce dusting of concrete
Application
Coverage: Ready-to-use. Do not dilute. Form surfaces should be clean of dirt, rust, scale and concrete buildup prior to application. Spray application of Form Release 250 is recommended with coverage as shown below.
Form Release 250 should be spray applied using an atomizing or misting spray tip so that application may be in thin uniform films to maximize product performance and economy. Over-application will not produce better results and may cause dusting. Excess material or puddles should be removed with a squeegee and absorbent rags.
When properly applied, Form Release 250 will not leave any residue or stain on the concrete, producing a smooth, architectural concrete surface ready for subsequent coatings. Coating manufacturer’s recommendations for surface preparations must be followed.
Sprays easily in cold temperatures. Proper application substantially reduces concrete surfaces voids and extends the life of wood forms.
Standards
Form Release 250 meets VOC emission requirements for form releases (EPA limit < 450 g/L).
• VOC content <250 g/L
• Corps of Engineers CEGS-03300, Section 10.8
Form Coating
• Navy Dock and Piers 56359
Packaging
Form Release 250 is packaged in 275 gallon totes, 55 gallon drums and 5 gallon pails.
Shelf Life
Store material in the original tightly closed containers.
Do not allow the accumulation of water, dirt or other contaminants. Shelf life of Form Release 250 in the original tightly closed containers is two years from date of manufacture.
Coverage Rates
Steel, Plastic, Fiberglass …………………….2000 sq ft/gal Conditioned Aluminum ……………………….2000 sq ft/gal HDO Plywood ……………………………………2000 sq ft/gal MDO Plywood ……………………………………1500 sq ft/gal Dimensional Lumber …………………………..1000 sq ft/gal BB Grade Plywood ……………………………..1000 sq ft/gal
Actual application rates depend on the porosity of form surface.
www.surebuilt-usa.com
Call 708-493-9569

Limitations / Precautions
Form Release 250 should not be used as a bond breaker in tilt up construction.
DO NOT EXPOSE TO OR APPLY NEAR FIRE OR FLAMES. FOR WELL VENTILATED OR EXTERIOR USE ONLY!
NOTICE-READ CAREFULLY CONDITIONS OF SALE
SureBuilt offers this product for sale subject to and limited by the warranty which may only be varied by written agreement of a duly authorized corporate officer of SureBuilt. No other representative of or for SureBuilt is authorized to grant any warranty or to waive limitation of liability set forth below.
WARRANTY LIMITATION SureBuilt warrants this product to be free of manufacturing defects. If the product when purchased was defective and was within use period indicated on container or carton, when used, SureBuilt will replace the defective product with new product without charge to the purchaser. SureBuilt makes no other warranty, either expressed or implied, concerning this product. There is no warranty of merchantability. NO CLAIM OF ANY KIND SHALL BE GREATER THAN THE PURCHASE PRICE OF THE PRODUCT IN RESPECT OF WHICH DAMAGES ARE CLAIMED.
INHERENT RISK
Purchaser assumes all risk associated with the use or application of the product.
840 South 25th Ave Bellwood, IL 60104 708-493-9569 www.surebuilt-usa.com